In addition to this kit, you will need to purchase the following parts from your local BRP dealer to make up your additional pump stage. Your existing pump will be your second stage:
Parts Required For All Engine Models:
x1 Aluminum Pump housing - P/N: 271002018
x1 Pump Bearing - P/N: 267000900
x1 Outer Pump Seal - P/N: 293200089
x2 Main Pump Seal - P/N: 271002071
x2 Cone O-ring - P/N: 293300086
x1 O-ring - P/N: 293300090
x1 C-Clip - P/N: 293370038
x1 Pump Suction Tubes - P/N: 271000785
(AND)
Impellers/Wear Rings Recommended For 215hp - 230hp Models:
x1 Front Pump Wear Ring 159mm - P/N: 267000372
x1 Rear Pump Wear Ring 150mm - P/N: 267000897
x1 Front Pump Impeller - Solas 9/14 - P/N: SRZ-FY-09/14
x1 Rear Pump Impeller 12/14 - P/N: 267001046
(OR)
Impellers/Wear Rings Recommended For 255hp - 260hp Models:
x1 Front Pump Wear Ring 159mm - P/N: 267000372
x1 Rear Pump Wear Ring 155mm - P/N: 267001036
x1 Front Pump Impeller - Solas 9/14 - P/N: SRZ-FY-09/14
x1 Rear Pump Impeller 12/19 - P/N: 267000940
(OR)
Impellers/Wear Rings Recommended For 300hp Models:
x1 Front Pump Wear Ring 161mm - P/N: 267000917
x1 Rear Pump Wear Ring 155mm - P/N: 267001036
x1 Front Pump Impeller - Solas 9/14 - P/N: SX-FY-09/14
x1 Rear Pump Impeller 12/19 - P/N: 267000940
OPTIONAL:
Tools required for installation/maintenance:
Female 22 Spline Tool - P/N: 529035892
Male 22 Spline Tool - P/N: 529035820
Male 28 Spline Tool - P/N: 529035956 (Solas Impellers SX-FY-09/14 and SRZ-FY-09/14 include this tool)
NOZZLE:
To achieve maximum performance out of your two stage pump system, it is recommended to purchase an aftermarket nozzle with smaller replaceable nozzle rings. RPM tuning can be achieved through smaller nozzle rings. Changing to a smaller nozzle size will lower RPM and give better performance out of the hole. Nozzle size may also be reduced to improve performance as pump parts get damaged over time. As pump slipping starts to occur and max RPM increases, a smaller nozzle will lower rpm and reduce slipping out of the hole.
Recommended Nozzle Sizes For Impellers Listed Above:
215hp: 80mm Nozzle
230hp: 79mm Nozzle
255hp: 83mm Nozzle
260hp: 83mm Nozzle
300hp: 83mm Nozzle
